Mitsubishi Electric MELDAS 600M Series Instruction Manual page 177

Number
37 0015 Meas ext
37 0020 Sys1 draw
37 0021 Sys1 draw
37 0022 Sys1 draw
37 0023 Sys2 draw
37 0024 Sys2 draw
37 0025 Sys2 draw
37 0030 Length
37 0031 L meas slow
37 0032 L meas slow
37 0040 Program
37 0041 STN contrast This adjusts the contrast of STN display.
37 0042 Space mode
37 0043 Invalid gray
37 0044 Work center
37 0045 Work center
37 0046 List
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Name
This invalidates the extended menu (Coordi EXT,
menu invld ∗
SkipPos take in) on the Workpiece Measurement and
Rotation Measurement screens.
This sets the control axis address when drawing
plane ax1 System 1.
plane ax2
plane ax3
This sets the control axis address when drawing
plane ax1 System 2.
plane ax2
plane ax3
[Automatic tool length
measure measurement]
speed
Deceleration
start point
area r
r
d
d
area d
This selects the method for saving the program in the
save type Edit screen.
0: Save program being edited with Save file menu.
1: Save program being edited each time the
INPUT key is pressed.
This selects the method of displaying the program on
in Editor the Edit screen.
0: Display the texts as that was input.
1: Display with inserting a space between each
word.
This shows or hides the menus that cannot be
menu ∗
operated.
0: Display as gray menus.
1: Do not display.
Set the workpiece rotation center position on the
pos H machine coordinate system for each axis, using the
table angle as 0 degrees. (Valid only during manual
operation.)
pos V
The list comments are changed when HD, FLD or IC
comment card is selected as the Device on the Input/Output
type screen, etc.
0: The date and time are displayed as the comment.
1: The file comment is displayed.
search engine
3. Setup Screens
Details
This sets the
feedrate during
automatic tool
Start point
length
measurement.
This sets the
distance from
the
Measurement
measurement
speed
measurement point to the
point
deceleration
start point.
This sets the
area of the point
where the tool
should stop.
I – 162
Setting range (units)
Extended menu
0: Display
1: Do not display
Axis name
Axis name
1 to 60000 (mm/min)
0 to 999999.999 (mm)
0 to 999999.999 (mm)
0,1
0 to 15
0,1
0,1
–999999.999 to
999999.999 (mm)
0,1