Table of Contents
Advertisement
(2) Menus
measure
measure
Downloaded from
ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Menu
This changes the mode to the tool length
T-leng
measurement mode. (The cursor moves to the length
dimension position for tool offset type II.)
This changes the mode to the tool radius
measurement mode. (This is valid only for tool length
T-rad.
measurement II.) (The cursor moves to the radius
dimension position for tool offset type II.)
Random values can be input in each data item of M
and T on the screen.
Manual
value
When the numeric value is input, the selected M and T
functions are executed.
This sets the reference surface height data. (The
cursor moves to the reference surface height.)
Surface
When the data is set in the setting area and the
hight
key is pressed, the reference surface height
INPUT
is set.
When the offset No. is set and the
pressed, the tool offset data with that number at its
Offset
No.
head appears.
The cursor moves to the length dimension data of the
top line of that data.
This writes the value displayed in "Meas value" as the
tool offset amount.
Offset
write
The wear amount is cleared to "0" for the tool offset
type II.
search engine
3. Setup Screens
Details
key is
INPUT
I – 200
Type
Reference
3.9.1 Carrying
C
out tool length
measurement
3.9.2 Carrying
out tool radius
C
measurement
1.5.1 Setting a
manual value
A
command
A
3.1 Tool offset
amount screen
A
C
–
Advertisement
Table of Contents
