Encapsulation Dot1Q - Cisco Nexus 7000 Series Command Reference Manual

encapsulation dot1q

encapsulation dot1q
To configure the matching criteria for mapping dot1q frames on an ingress interface to this interface, use
the encapsulation dot1q command.
Syntax Description vlan-id
Defaults
Deencapsulated
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines
The subinterfaces between the customer-edge (CE) and provide edge (PE) routers that are running
Ethernet over MPLS (EoMPLS) must be in the same subnet. All other subinterfaces and backbone
devices do not need to be in the same subnet.
This command requires the MPLS Services license.
Examples
This example shows how to configure the matching criteria for mapping dot1q frames on an ingress
interface to this interface:
switch# configure terminal
switch(config)# interface ethernet 4/0/0.1
switch(config-if)# encapsulation dot1q 100
switch(config-if)#
Related Commands Command
internetworking
l2vpn xconnect context Enters Xconnect configuration mode and establishes a Layer 2 VPN
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
142
encapsulation dot1q vlan-id
VLAN ID. The range is from 2 to 967.
Modification
This command was introduced.
Description
Specifies the type of pseudowire and the type of traffic that can flow across
the network
(L2VPN) context for identifying the two members in a VPWS, multi
segment pseudowire, or local connect service.
E Commands
OL-24994-01