Cisco Nexus 7000 Series Command Reference Manual page 274

session protection
session protection
To enable Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP) session protection,
use the session protection command. To return to the default setting, use the no form of this command.
Syntax Description
for
prefix-list
duration
seconds
infinite
Defaults None
Command Modes
LDP configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples
This example shows how to enable MPLS LDP session protection:
switch# configure terminal
switch(config)# mpls ldp configuration
switch(config-ldp)# session protection for prefix1 duration 100
switch(config-ldp)#
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1206
session protection [for prefix-list] [duration {seconds | infinite}]
no session protection [for prefix-list] [duration {seconds | infinite}]
(Optional) Specifies the prefix list that should be protected.
(Optional) Prefix list for label switched path (LDP) peers.
(Optional) Specifies the period to sustain the session protection after the
loss has been discovered by the link discovery process.
(Optional) Holdup time in seconds. The range is from 30 to 2147483.
(Optional) Specifies to protect the session forever after the loss has been
discovered by the link discovery process.
Modification
This command was introduced.
Description
Protocol (LDP).
S Commands
OL-24994-01