Cbts-Member Tunnel-Te - Cisco Nexus 7000 Series Command Reference Manual

cbts-member tunnel-te

cbts-member tunnel-te
To configure a class-based tunnel selection (CBTS) tunnel interface type, use the cbts-member
tunnel-te command. To restore the system to its default condition, use the no form of this command.
Syntax Description
number
Defaults None
Command Modes TE Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines You cannot configure the traffic engineering (TE) commands on these class-based tunnel selection
(CBTS) member tunnels (auto-bw; backup-bw; description; destination; fowarding-adjacency;
inherit; source).
All the tunnel-te configured commands, except for exp and path-option, are inherited by the
Note
CBTs-member LSP when they are configured on the tunnel headend interface. If the command is entered
independently of or on the CBTs-member LSP, it takes precedence and overrides the config on the tunnel
headend interface for that CBTs-member LSP. When the configuration is removed from the cbts-member
LSP, the configuration on the tunnel headend interface is inherited by the CBTs-member LSP.
This command requires the MPLS Services license.
Examples
This example shows how to configure a CBTS tunnel interface type:
switch# configure terminal
switch(config)# interface tunnel-te 1
switch(config-if-te)# cbts-member tunnel-te 251
switch(config-cbts-member)
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
122
cbts-member tunnel-te number
no cbts-member tunnel-te number
Tunnel interface number. The range is from 0 to 65503.
Modification
This command was introduced.
C Commands
OL-24994-01