Cisco Nexus 7000 Series Command Reference Manual page 195

M Commands
mpls ldp autoconfig
To enable Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP) autoconfiguration
for all level-1, all level-2, or all level-1 and level-2 IS-IS interfaces, use the mpls ldp autoconfig
command. To return to the default setting, use the no form of this command.
Syntax Description
level-1
level-1-2
level-2
Defaults
None
Command Modes Router configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to enable MPLS LDP autoconfiguration for all level-1, all level-2, or all level-1
and level-2 IS-IS interfaces:
switch# configure terminal
switch(config)# router isis p1
switch(config-router)# mpls ldp autoconfig level-1
switch(config-router)#
OL-24994-01
mpls ldp autoconfig {level-1 | level-1-2 | level-2}
no mpls ldp autoconfig {level-1 | level-1-2 | level-2}
Specifies the Multiprotocol Label Switching (MPLS) Label Distribution
Protocol (LDP) autoconfiguration (AC) on IS-IS level-1 only.
Specifies the Multiprotocol Label Switching (MPLS) Label Distribution
Protocol (LDP) autoconfiguration (AC) on IS-IS level-1 and level-2.
Specifies the Multiprotocol Label Switching (MPLS) Label Distribution
Protocol (LDP) autoconfiguration (AC) on IS-IS level-2 only.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
mpls ldp autoconfig
1147