Cisco Nexus 7000 Series Command Reference Manual page 202

mpls ldp igp sync
mpls ldp igp sync
To configure a delay time for Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP)
Interior Gateway Protocol (IGP) synchronization on the specified interface, use the mpls ldp igp sync
command. To return to the default setting, use the no form of this command.
Syntax Description
delay
seconds
Defaults None
Command Modes Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines The no mpls ldp igp sync delay command sets the delay time to 0 seconds but leaves the MPLS LDP
and IGP synchronization enabled.
This command requires the MPLS Services license.
Examples This example shows how to configure a delay time for the MPLS LDP and IGP synchronization on the
specified interface:
switch# configure terminal
switch(config)# feature mpls ldp
switch(config)# interface ethernet 6/1
switch(config-if)# mpls ldp igp sync delay 30
Related Commands Command
mpls ldp sync
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1154
mpls ldp igp sync [delay seconds]
no mpls ldp igp sync [delay seconds]
(Optional) Specifies LDP to IGP sync achieved notification delay time.
(Optional) Display in seconds. The range is from 5 to 60 seconds.
Modification
This command was introduced.
Description
Enables Multiprotocol Label Switching (MPLS) Label Distribution
Protocol (LDP) Interior Gateway Protocol (IGP) synchronization for all
IS-IS interfaces.
M Commands
OL-24994-01