Cisco Nexus 7000 Series Command Reference Manual page 199

M Commands
mpls ldp discovery transport-address
To configure the transport address that is advertised in the Label Distribution Protocol (LDP) discovery
hello messages sent on an interface, use the mpls ldp discovery transport-address command. To return
to the default setting, use the no form of this command.
Syntax Description
ip-address
interface
Defaults None
Command Modes Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to configure the transport address that is advertised in the LDP discovery hello
messages sent on an interface:
switch(config)# interface ethernet 6/1
switch(config-if)# mpls ldp discovery transport-address 209.165.200.225
switch(config-if)#
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
OL-24994-01
mpls ldp discovery transport-address {ip-address | interface}
no mpls ldp discovery transport-address {ip-address | interface}
IP address that is advertised as the transport address.
Specifies that the interface IP address be advertised as the transport address.
Modification
This command was introduced.
Description
Protocol (LDP).
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
mpls ldp discovery transport-address
1151