Cisco Nexus 7000 Series Command Reference Manual page 197

M Commands
mpls ldp autoconfig area
To enable Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP) autoconfiguration
for all Open Shortest Path First (OSPF) interfaces, use the mpls ldp autoconfig area command. To return
to the default setting, use the no form of this command.
Syntax Description
area-id
Defaults
None
Command Modes Router configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how to enable MPLS LDP autoconfiguration for all OSPF interfaces:
switch# configure terminal
switch(config)#
switch(config-router)# mpls ldp autoconfig area 10
switch(config-router)#
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
OL-24994-01
mpls ldp autoconfig area area-id
no mpls ldp autoconfig area area-id
Area ID as an integer or IP address. The range is from 0 to 4294967295.
Modification
This command was introduced.
p1
Description
Protocol (LDP).
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
mpls ldp autoconfig area
1149