Cisco Nexus 7000 Series Command Reference Manual page 245

R Commands
record-route (LSP attribute configuration mode)
To record the route used by the label switched path (LSP), use the record-route command.
Syntax Description
This command has no arguments or keywords.
Command Modes
LSP attribute configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
The following holds true for all tunnel-te commands that can be specified both in "TE interface
configuration mode" or path-option command line or "LSP attribute configuration mode":
If a setting is specified for an LSP, either via the path-option command directly or by assigning an LSP
attribute list to a path-option, takes precedence for that specific path-option.
If no setting is specified for an LSP, then the LSP/path-option inherits any setting specified in the
tunnel-te configuration mode: affinity, auto-bw, priority, record-route, protection/fast-reroute.
This command requires the MPLS Services license.
Examples
This example shows how to record the route by LSP:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# lsp attributes 1
switch(config-lsp-attr)# record-route
Related Commands Command
mpls traffic-eng
configuration
OL-24994-01
record-route
Modification
This command was introduced.
Description
Configures the Multiprotocol Label Switching (MPLS) Traffic Engineering
Protocol (MPLS-TE).
record-route (LSP attribute configuration mode)
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1197