Cisco Nexus 7000 Series Command Reference Manual page 226

path-selection metric (TE configuration mode)
path-selection metric (TE configuration mode)
To configure the metric type to use if a metric type is not explicitly configured for a Multiprotocol Label
Switching (MPLS) traffic engineering (TE) tunnel, use the path-selection metric command. To restore
the system to its default condition, use the no form of this command.
Syntax Description
igp
te
Defaults TE
Command Modes TE configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines If you configure the TE path selection metric type, you should configure the MPLS TE administrative
weight on each interface for which TE is enabled.
Use this command to specify the metric type to be used for traffic engineering (TE) tunnels for which
the tunnel path-selection metric command has not been specified.
The metric type to be used for path calculation for a given tunnel is determined as follows:
•If you entered the tunnel path-selection metric command to specify a metric type for the tunnel, use
that metric type.
•If you entered the TE configuration mode path-selection metric was entered to specify a metric type,
use that metric type.
•If you did not do any of the above tasks, use the default (te) metric.
This command requires the MPLS Services license.
Examples This example shows how to configure the metric type to use if a metric type is not explicitly configured
for an MPLS TE tunnel:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1178
path-selection metric {igp | te}
no path-selection metric
Specifies the Interior Gateway Protocol (IGP) metric.
Specifies the traffic engineering (TE) metric.
Modification
This command was introduced.
P Commands
OL-24994-01