Isis Metric - Cisco Nexus 7000 Series Command Reference Manual

I Commands

isis metric

To configure the Intermediate System-to-Intermediate System (IS-IS) metric for a tunnel interface to be
used as a forwarding adjacency, use the isis metric command.
Syntax Description metric-value
level-1
level-2
Command Modes TE interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines Specify the isis metric command with level-1 or level-2 to be consistent with the IGP level at which you
are performing traffic engineering; otherwise, the metric default value is 10.
Use this command only if the IGP is IS-IS. If the IGP is OSPF, use the equivalent OSPF command.
This command requires the MPLS Services license.
Examples This example shows how to configure the IS-IS metric for a tunnel interface to be used as a forwarding
adjacency:
switch# configure terminal
switch(config)# interface tunnel-te 1
switch(config-if-te)# forwarding-adjacency
switch(config-if-te)# isis metric 2 level-1
switch(config-if-te)#
Related Commands Command
interface tunnel-te
OL-24994-01
isis metric metric-value {level-1 | level-2}
Default metric. The range is from 0 to 16777215.
Specifies the metric to level 1 links.
Specifies the metric to level 2 links.
Modification
This command was introduced.
Description
Configure the traffic engineering interface.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
isis metric
199