Affinity (Lsp Attribute Configuration Mode) - Cisco Nexus 7000 Series Command Reference Manual

affinity (LSP attribute configuration mode)

affinity (LSP attribute configuration mode)
To configure attribute flags for links that comprise a label switched path (LSP), use the affinity
command.
Syntax Description mask
value
Defaults Value default is 0x00000000
Mask default is 0x0000ffff
Command Modes LSP attributes configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines The following holds true for all tunnel-te commands that can be specified both in "TE interface
configuration mode" or path-option command line or "LSP attribute configuration mode":
If a setting is specified for an LSP, either via the path-option command directly or by assigning an LSP
attribute list to a path-option, takes precedence for that specific path-option.
If no setting is specified for an LSP, then the LSP path-option inherits any setting specified in the tunnel-te
configuration mode: affinity, auto-bw, priority, record-route, protection/fast-reroute.
This command requires the MPLS Services license.
Examples This example shows how to configure attribute flags for links that comprise an LSP:
switch# configure terminal
switch(config)# mpls traffic-eng configuration
switch(config-te)# lsp attributes 1
switch(config-lsp-attr)# affinity 0X0101 mask 0X0303
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
18
affinity [mask value]
(Optional) Link attribute to be checked. A 32-bit decimal number. Valid
values are from 0x0 to 0xFFFFFFFF, representing 32 attributes (bits),
where the value of an attribute is 0 or 1.
Attribute values required for links carrying this tunnel. A 32-bit decimal
number. Valid values are from 0x0 to 0xFFFFFFFF, representing 32
attributes (bits), where the value of an attribute is 0 or 1.
Modification
This command was introduced.
A Commands
OL-24994-02