Cisco Nexus 7000 Series Command Reference Manual page 185

M Commands
member
To add an active Ethernet AC, with or without an Ethernet Flow Point (EFP), to the context, use the
member command. To delete the member configuration, use the no form of this command.
Syntax Description interface-type
ip-address ip-address
ethernet
slot/port-number
port-channel
port-channel-number
pseudowire pw-id
service-instance
service-instance-id
group
group-name
priority
number
Defaults
None
Command Modes config-xconnect configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
OL-24994-01
member interface-type {ip-address ip-address | ethenet slot/port-number | port-channel
port-channel- number | pseudowire pw-id} [service-instance service-instance-id] [group
group-name] [priority number]
no member interface-type {ip-address ip-address | ethenet slot/port-number | port-channel
port-channel- number | pseudowire pw-id} [service-instance service-instance-id] [group
group-name] [priority number]
Interface type.
Specifies the IPv4 or IPv6 address of the peer.
Specifies the Ethernet IEEE 802.3z interface. The range for the slot is from
1 to 253.
Specifies the port channel interface. The range for the port channel is from
1 to 4096.
Specifies the pseudowire interface. The pw-ID is a unique per-interface
identifier for this pseudowire. The range is from 1 to 200000. The range for
a static pseudowire is from 1 to 8192.
(Optional) Specifies the service instance.
Service instance ID. The service-instance-id is a unique per-interface
identifier for the EFP. The valid range is from 1 to 4000.
(Optional) Specifies the group to which the member belongs.
Group name. The group-name can be a maximum of 31 alphanumeric
characters.
(Optional) Specifies the priority.
Priority number. The range is from 1 to 10, with 1 being the highest priority.
The default is 0 and is higher than 1.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
member
1137