Area - Cisco Nexus 7000 Series Command Reference Manual

area

area
To configure the sham link on the provider edge (PE) interface within a specified Open Shortest Path First
(OSPF) area and with the loopback interfaces specified by the IP addresses as endpoints, use the area
command
Syntax Description
area-id
sham-link
virtual-link
source-address
destination-address
Defaults
None
Command Modes
Router configuration mode
Supported User Roles network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines
This command requires the MPLS Services license.
Examples This example shows how to configure the maximum number of routes that can be stored in the virtual
routing and forwarding (VRF) route table:
switch# configure t
switch(config)# feature ospf
switch(config)# router ospf p1
switch(config-router)# timer throttle lsa 0 50 500
switch(config-router)# vrf vpn1
switch(config-router-vrf)# area 1 sham-link 10.2.1.1 10.2.1.2
switch(config-router-vrf)#
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
112
.
To return to the default setting, use the no form of this command.
area area-id sham-link source-address destination-address
no area area-id sham-link source-address destination-address
Area ID as an integer or IP address.
Specifies the sham link and its parameters.
Specifies a virtual link and its parameters.
Source address.
Destination address.
Modification
This command was introduced.
A Commands
OL-24994-02