Cisco Nexus 7000 Series Command Reference Manual page 344

show l2vpn atom vc detail
show l2vpn atom vc detail
To display detailed information about Any Transport over MPLS (AToM) virtual circuits (VCs) and
static pseudowires that have been enabled to route Layer 2 packets on a device, use the show l2vpn atom
vc detail command.
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes
Any command mode
Supported User Roles network-admin
vdc-admin
Command History Release
6.2.2
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display detailed information about Any Transport over MPLS (AToM)
virtual circuits (VCs) and static pseudowires that have been enabled to route Layer 2 packets on a device:
switch# show l2vpn atom vc detail
pseudowire100002 is down, VC status is down
Create time: 4w6d, last status change time: 5w5d
Destination address: 10.0.0.4 VC ID: 80
Member of vfi service vpls-80
Signaling protocol: LDP, peer unknown
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
1266
show l2vpn atom vc detail
Modification
This command was introduced.
Last label FSM state change time: 4w6d
Output interface: none, imposed label stack {}
Preferred path: not configured
Default path: no route
No adjacency
Service id: 0xc3000001
Targeted Hello: 0.0.0.0(LDP Id) -> 10.0.0.4, LDP is DOWN, no binding
Graceful restart: not configured and not enabled
Non stop routing: not configured and not enabled
PWid FEC (128), VC ID: 80
Status TLV support (local/remote)
LDP route watch
Label/status state machine
Local dataplane status received
: enabled/None (no remote binding)
: enabled
: provisioned, LndRnd
: No fault
Show Commands
OL-24994-01