Notes Of When Rt Toolbox3 Is Used With Iq Works (Melsoft Navigator); Notes Of When Rt Toolbox3 Is Installed; Notes Concerning Workspace Operation - Mitsubishi Electric MELFA FR CR800 Series User Manual

4. Notes of when RT ToolBox3 is used with iQ Works
(MELSOFT Navigator)
There are some limitations when robot controller's workspace is made by using iQ Works (MELSOFT Navigator)
or RT ToolBox3 is started from iQ Works (MELSOFT Navigator). Please refer to the following notes when you use iQ
Works (MELSOFT Navigator).

4.1. Notes of when RT ToolBox3 is installed

Please input product ID attached to the product again when you install a
Notes 1-1：
standard version of RT ToolBox3 in the personal computer in which "iQ Works
(MELSOFT Navigator" is installed.
When RT ToolBox3 is installed in the personal computer in which "iQ Works (MELSOFT Navigator)" is
installed, product ID for "iQ Works (MELSOFT Navigator)" is displayed on "Input Product ID" screen. RT
ToolBox3 is installed in the personal computer as mini version when this software is installed with this Product
ID. Please input product ID attached to RT ToolBox3 product again when you install a standard version of RT
ToolBox3.

4.2. Notes concerning workspace operation

The workspace name and the workspace title cannot be changed.
Notes 2-1：
When RT ToolBox3 is started from iQ Works (MELSOFT Navigator), the workspace name and the
workspace title cannot be changed. "Edit workspace" in the dropdown menu of the workspace name is
displayed in the gray and cannot be selected. (Refer to "Figure 4-1 Menu of [Workspace] and
Dropdown-menu of the Workspace")
Please close RT ToolBox3 once when you edit another workspace.
Notes 2-2：
Another workspace cannot be opened after closing the editing workspace when RT ToolBox3 is started
from iQ Works (MELSOFT Navigator). [New] of the [Workspace] menu and [Open] are displayed in the gray,
and cannot be selected. (Refer to "Figure 4-1 Menu of [Workspace] and Dropdown-menu of the
Workspace") When you edit another workspace, please exit RT ToolBox3 once and start RT ToolBox3
specifying another workspace from iQ Works (MELSOFT Navigator).
It is not possible to save as another name when the workspace is edited.
Notes 2-3：
The editing workspace cannot be saved as another name when RT ToolBox3 is started from iQ Works
(MELSOFT Navigator). [Save As] in [Workspace] menu is displayed in the gray and cannot be selected.
4-58 4-58