Flow Of Operations - Mitsubishi Electric MELFA FR CR800 Series User Manual

18.9.3. Flow of operations

Select the target robot (<a>)
Select the tool number for setting (<b>)
Re-teaching Work Procedure
Move the robot to the auxiliary point
(Use the teaching box)
Select the line of "Auxiliary point" (<c>)
Teach selection line (<d>)
Enter checks to the check box of the line
used to calculation (<c>)
(After teaching, the check box is updated)
Write the tool coordinate to robot controller (<e>)
18-465
Repeat as necessary
(When a value is set to "Calculated tool coordinate",
a [Write] button (<e>) becomes effective)
Figure 18-73 Operation Flow
18-465