Mitsubishi Electric MELFA FR CR800 Series User Manual page 285

(2) Display format
The value displayed in variable monitor, signal monitor, and register monitor can be switched.
Table 14-3 Change display of variable monitor, signal monitor, register monitor
Integer
Real
Variable
monitor
String
Position
Data
Signal
Register
As for the value displayed by the hexadecimal number, "&H" is added to the head of the value.
(3) Signal check box
Display / non-display of signal monitor by ON / OFF of check box.
(4) Register check box
Display / non-display of Register monitor by ON / OFF of check box.
Register check box is not displayed if option card is not installed.
(5) Variable monitor:
You can check the names of variables being used in the selected program. You can select the variables to
monitor with the buttons displayed at the bottom of the screen.
(6) Adding variables
This adds more variables to monitor.
14-285
The displayed variable can be switched between hexadecimal / unsigned
decimal / signed decimal.
It is possible to switch between hexadecimal / signed decimal if 0 under the
decimal point.
However, the value can only be displayed within a range of -9999999 -
9999999.This will be displayed as a floating point if this range is exceeded.
Can not switch display.
Switching display is not performed for both orthogonal / joint / work
coordinate
The displayed variable can be switched between hexadecimal / unsigned
decimal / signed decimal.
The displayed variable can be switched between hexadecimal / unsigned
decimal / signed decimal.
Figure 14-5 Add Variables
A dropdown list
is displayed.
Move to the variable
name that matches the
input character
14-285