Mitsubishi Electric MELFA FR CR800 Series User Manual page 157

11.7.4.17. Renumbering
The renumbering function can only be used with MELFA-BASIC IV and Movemaster commands.
You can renumber line numbers in a batch. You can specify a range for renumbering.
With the setting dialog, you can specify the start and end line numbers, the new starting line number, and the line
number interval.
During editing of programs created using MELFA-BASIC IV or Movemaster commands, click the [Tool] tab -> [Line#]
-> [Renumber] button on the ribbon. The renumber set screen is displayed.
Caution
Renumbering can only be used with MELFA-BASIC IV and
Movemaster commands.
The renumbering function can only be used with MELFA-BASIC IV and Movemaster commands.
This function is not available in MELFA-BASIC V and MELFA-BASIC VI.
11.7.4.18. Sort
The sort function is available only with MELFA-BASIC IV and Movemaster commands.
This sorts the edited program by line number.
During editing of programs created using MELFA-BASIC IV or Movemaster commands, click the [Tool] tab -> [Line#]
group -> [Sort] button on the ribbon. The confirmation message is displayed, then the line numbers are sorted in
ascending order.
Caution
Sort is available only with MELFA-BASIC IV and Movemaster
commands.
The sort function is available only with MELFA-BASIC IV and Movemaster commands.
This function is not available in MELFA-BASIC V and MELFA-BASIC VI.
11-157
Figure 11-52 Renumber Setting Screen
Figure 11-53 Sort
11-157