Table of Contents
Advertisement
23.5. I/O Simulator Connection Status
When the "Simulator setting" screen is opened when the I/O simulator is started up, the connection status to the
robot simulator and GX Simulator2/3 that are to be connected to the I/O simulator can be checked.
When each of the [Setting side], [Condition1/Source] and [Condition2] cells in the signal connection list are
displayed in red, this means that the simulator displayed in those cells is not yet connected.
When there are simulators that are not yet connected, check the following:
Is the simulator to be connected started up?
In the case of GX Simulator2/3, is the startup order correct?
23.6. Stopping I/O simulator
To exit the I/O simulator, click the [Online] tab -> [I/O Simulator] group [Exit] button on the ribbon. Or, click the I/O
simulator icon on the task tray, and select [Exit] in the menu that is displayed.
When the simulation stops and the connection status is offline, I/O simulator stops simultaneously.
23-621
Simulators that are not yet connected
Figure 23-15 I/O Simulator Connection Status
Figure 23-16 Stopping I/O simulator
Stopping I/O simulator
23-621
Advertisement
Table of Contents
