Table of Contents
Advertisement
11.13.5.
Rename
This renames a program file name.
Select the name of only one program to be renamed from the lists. Programs can be selected in the Source and
Destination lists. Click the [Rename] buttons under the Source and Destination lists, set the new name in the
[Setup for Rename] dialog, and click the [OK] button to rename the program.
A program which is set with "Reading protection" cannot be renamed.
11.13.6.
Protect settings
The program files in the controller can be protected. Settings can be made to protect the entire program file or
just the command statements or position variables, as well as protection against readout, and protection release
is possible
You cannot move, delete, or rename a protected file. Release the protection prior to any of these operations.
Select the names of the programs to be protected from the lists. Multiple programs can be selected in the Source
and Destination lists. Click the [Protect] buttons under the Source and Destination lists, set the protect details in
the [Setting for protect] dialog, and click the [OK] button to protect the program details.
Caution
The only programs to which protect operations apply are programs in robot
controllers.
If you change the "Read protection status, the following "Register a reading password" or "The reading password
delete" screens are displayed. Input the password to register or delete and click the [OK] button.
11-186
Figure 11-87 Rename Screen
Figure 11-88 Protect Settings Dialog
11-186
Advertisement
Table of Contents
