Set A Breakpoint - Mitsubishi Electric MELFA FR CR800 Series User Manual

Caution
Breakpoints are available only with MELFA-BASIC V and
MELFA-BASIC VI.
11.11.5.

Set a Breakpoint

Set a Breakpoint
Set a breakpoint by the following procedure.
1) Move the cursor to the command line where you want to set a breakpoint, click [Debug] ->
[Breakpoint] group-> [Set] on the ribbon, or click the left side of the command line to be set.
2) The breakpoint setting screen is displayed during debugging.
Select the type of breakpoint to set, and then click the [OK] button. The breakpoint is set at the
specified command line.
3) " " is displayed at the left end of command lines at which breakpoints are set.
11.11.5.1. Delete a Breakpoint
Delete a Breakpoint
To delete the breakpoint, the cursor moves to the command line where the breakpoint is to be deleted.
Click [Debug] -> [Breakpoint] group -> [Delete] on the ribbon, or click on the left side of the command line
to be deleted.
To delete all breakpoints set to a program, click the [Debug] tab -> [Breakpoint] group -> [Delete All] button
on the ribbon.
The setting and delete of the breakpoint can also be operated through the buttons on the ribbon.
11-178
Figure 11-74 Setting a Breakpoint
Figure 11-75 Display of Lines with Breakpoints Set
11-178