Mitsubishi Electric MELFA FR CR800 Series User Manual page 151

11.7.4.10. Jump to label /
If you left-click while holding down the [Ctrl] key for the label name or the procedure name of the instruction editing
area, jump to the corresponding definition line.
The robot program language corresponding to this function is as follows.
11.7.4.11. Partial writing
Writes the selected program lines to the robot controller.
This is handy for reflecting the contents of a partially revised program in the robot controller. But be careful, only the
selected part of the program is written.
Select the line to write to the robot controller, and click the [Edit] tab -> [Transmission] group -> [Partially] button on
the ribbon.
Check the contents to be written, and then click [Yes].
11-151
procedure definition line
Table 11-4 Job correspondence table for robot program language
Program Language
MELFA-BASIC VI
MELFA-BASIC V
MELFA-BASIC IV
Movemaster commands
Figure 11-47 Jump screen to label definition line
Figure 11-48 Partial Writing
Label procedure
○ ○
○
×
○
×
× ×
○: Enable ×: Disable
[Ctrl] + Left-click
Jump to definition line
11-151