Mitsubishi Electric MELFA FR CR800 Series User Manual page 152

11.7.4.12. Transfer all lines of the program
Write the all lines of the program to the robot controller.
With the program opened, click the [Edit] tab -> [Transmission] group -> [All] button on the ribbon. After displaying
the confirmation message, and then click "Yes".
11.7.4.13. Syntax check
You can check whether or not an edited robot program is syntactically correct. Execute this before writing a program
to the robot controller.
Click the [Edit] tab -> [Command line] group -> [Syntax check] button on the ribbon. If there is a syntax error, the
error location and details are displayed.
Date that syntax check was
executed
Program name
You can jump to the command statement containing an error by double-clicking the detected error.
11-152
Error content
Project name
Number of lines where error was detected
Figure 11-49 Syntax Check Results Screen
Jump by double-clicking
Program location (robot controller/PC)
Line content Error details
11-152