Table of Contents
Advertisement
13.3.12.
Movement parameters
You can set information related to the optimum acceleration/deceleration for robot operation and set compliance
errors.
The information that can be set concerning movement parameters depends on the robot controller connected.
Table 13-8 The controller which you can set information related to optimum acceleration/deceleration for robot
Maximum acceleration/deceleration
correction ratio
Compliance error function settings
Optimum acceleration/deceleration
setting
Direction of gravity
Set parameters while connected to the robot controller.
Double-click [Movement parameter] -> [Movement] under the [Parameter] item to be edited from the project tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
You can reference explanations of the displayed parameters by pressing the [Explain] button.
13-230
operation and set compliance errors
CR800/CR750/700 series
Can be used with all versions
Figure 13-30 Movement parameter
CRn-500 series
J2 edition or later
H6 edition or later
G1 edition or later
H4 edition or later
13-230
Advertisement
Table of Contents
