13.1. Editing from parameter list
You can reference and rewrite individual items of parameter information set in a robot controller by specifying the
name of the parameter.
13.1.1. Starting
This is used in a state with the robot controller connected.
Double-click [Parameter list] under the [Parameter] item to be edited from the project tree.
Figure 13-2 Starting the Parameter List
At this time, a confirmation message like the following concerning the parameter list is displayed.
Figure 13-3 Confirmation Message for Parameter List
This window will appear in the following cases.
- When there is no parameter list information on the personal computer.
- When the parameter list used in the robot controller is newer than the parameter list already stored in the
personal computer.
13-208
13-208