Mitsubishi Electric MELFA FR CR800 Series User Manual page 108

9.2.5.5. When Ethernet is selected
When "Ethernet" is selected as the computer interface, the communications routes that you can select are as
follows.
Table 9-9 Communication Routes That Can Be Selected for "Ethernet"
No.
1 Ethernet board communication Access other station via Ethernet module
2 Ethernet board communication Access Ethernet-serial communication other
station via Ethernet module
3 Ethernet board communication Access Ethernet-CC-Link other station via
Ethernet module
4 Ethernet port direct communication PLC module connection
5 Ethernet port direct communication Access serial communication other station
via PLC module
6 Ethernet port direct communication Access CC-Link other station via PLC
module
7 Ethernet port IP address designate communication PLC module connection
8 Ethernet port
communication other station via PLC module
9 Ethernet port IP address designate communication Access CC-Link other
station via PLC module
Figure 9-11 Ethernet (Ethernet board communication Access Ethernet-serial communication other station via Ethernet
"(1)PC side I/F Ethernet board setting", "(2)Network communication route setting Ethernet", "(5)Network
communication route setting of MNET/10", and "(6)Coexistence network route setting of C24" may not be settable
depending on the network route selected.
9-108
Communications Route
IP address designate
module) Detailed Settings
communication Access
Special mention
serial
9-108