Figure 10-1 Provisioning Line Parameters On The Ds-1 Ports - Cisco ONS 15327 Procedure Manual

Chapter 10 Change Port Settings

Figure 10-1 Provisioning Line Parameters on the DS-1 Ports

Step 3 Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
VT1.5 Path Threshold, or Alarm Behavior subtab.
Note
Modify any of the settings found under these subtabs.
Step 4
For definitions of the line settings, see
Table 10-2 on page
For the factory default settings for the DS-1 ports, see
Click Apply.
Step 5
Repeat Steps
Step 6
Table 10-1
March 2003
See Chapter 6, "Manage Alarms"
10-4. For definitions of the electrical path settings, see
4 and 5 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line subtab for the DS-1 ports.
NTP-B88 Modify Line Settings and PM Parameter Thresholds for Electrical Ports
for information about the Alarm Behavior subtab.
Table 10-1. For definitions of the line threshold settings, see
Table C-1 on page
Cisco ONS 15327 Procedure Guide, R4.0
Table 10-3 on page 10-5.
C-5.
10-3