Ntp-B200 View Xtc Cross-Connect Resource Usage - Cisco ONS 15327 Procedure Manual

Chapter 8 Manage Circuits
Note
Step 3 Return to your originating procedure (NTP).

NTP-B200 View XTC Cross-Connect Resource Usage

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 Log into the node where you want to view the cross-connect card resource usage. See the
into CTC" task on page 2-23
Step 2 Click the Maintenance > Cross-Connect tabs.
Step 3 In the Summary section of the Resources Usage tab, view the following information:
•
•
•
In the VT Port Matrix Detail section, you can view details of the VT Matrix Port usage:
Step 4
•
•
•
•
Stop. You have completed this procedure.
March 2003
You can perform other procedures from the Circuits on Span dialog box. If the span is in a path
protection, you can switch the span traffic. See
Switch" task on page 13-16
double-click the circuit. See the
"DLP-B233 Edit Path Protection Circuit Path Selectors" task on page 8-11
This procedure displays the percentage of XTC cross-connect resources
used by circuits that traverse or terminate at an ONS 15327.
None
As needed
Onsite or remote
Retrieve or higher
for instructions. If you are already logged in, continue with Step 2.
STS-1 Paths—Provides the percent of the XTC cross-connect STS-1path resources that are used.
288 STS-1 paths are available.
VT Matrix Ports—Provides the percent of the XTC cross-connect VT matrix ports that are used.
Each port is one STS in size, and each can transport 28 VT1.5s. 24 VT matrix ports are available.
VT Matrix—Provides the percent of the VT matrix resources that are used. 672 are available, which
is the number of VT matrix ports (24) multiplied by the number of VT1.5s in an STS (28).
Drop—Identifies the source slot, port, and STS.
Tunnel Name—If the VT port is on a VT tunnel origination or termination port, the name of the VT
tunnel appears in Tunnel Name.
% Used—Shows the percent of the matrix port that is used. Each matrix port can carry 28 VT1.5s,
so for example, if one STS carries seven VT1.5 circuits, the matrix port will be 25% used.
Usage—Shows the port usage. For example, if one STS carries seven VT1.5 circuits, the matrix port
will show 7 of 28 are used.
NTP-B200 View XTC Cross-Connect Resource Usage
"DLP-B197 Initiate a Path Protection Force
for instructions. If you want to edit a circuit on the span,
"DLP-B231 Edit a Circuit Name" task on page 8-9
Cisco ONS 15327 Procedure Guide, R4.0
or the
for instructions.
"DLP-B60 Log
8-7