Ntp-B38 Provision A Linear Adm Network; Figure 4-1 Linear Adm Configuration - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 4
Turn Up Network
NTP-B38 Provision a Linear ADM Network
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into an ONS 15327 that you want to provision in a linear ADM network. See the
Step 1
into CTC" task on page 2-23
Figure 4-1
flows from Slot 3/Node 1 to Slot 3/Node 2, and from Slot 2/Node 2 to Slot 2/Node 3. You create the
protect path by placing Slot 3 in 1+1 protection with Slot 1 at Nodes 1 and 2, and Slot 2 in 1+1 protection
with Slot 4 at Nodes 2 and 3.
Figure 4-1
Node 1
Click the Provisioning > Protection tabs. Verify that 1+1 protection is created for the OC-N cards at
Step 2
the node. If the protection group has not been created, go to the
Groups" procedure on page 3-20
Repeat Steps
Step 3
Verify that the working and protect cards in the 1+1 protection groups correspond to the physical fiber
Step 4
connections between the nodes, that is, working cards are fibered to working cards and protect cards are
fibered to protect cards.
Complete the
Step 5
OC-N ports on each linear ADM node.
Note
Note
March 2003
This procedure provisions three or more ONS 15327s in a linear add-drop
multiplexer (ADM) configuration.
None
NTP-B35 Verify Node Turn Up, page 4-2
As needed
Onsite
Provisioning or higher
for instructions. If you are already logged in, continue with Step 2.
shows three ONS 15327s in a linear ADM configuration. In this example, working traffic
Linear ADM Configuration
Slot 3 to Slot 3
Slot 1 to Slot 1
to create them.
1
and
2
for all other nodes you will include in the linear ADM.
"DLP-B253 Provision SONET DCC Terminations" task on page 4-5
If linear ADM nodes are not connected to a LAN, you will need to create the DCC terminations
using a craft (direct) connection to the node. Remote provisioning is possible only after all nodes
that do not have LAN connections have DCC terminations provisioned to in-service OC-N ports.
Terminating nodes will have one DCC termination (Nodes 1 and 3 in
and intermediate nodes will have two DCC terminations (Node 2/Slot 3 and Node 2/Slot 2 in
Figure
4-1).
Slot 2 to Slot 2
Slot 4 to Slot 4
Node 2
"NTP-B170 Create Optical Protection
Cisco ONS 15327 Procedure Guide, R4.0
NTP-B38 Provision a Linear ADM Network
"DLP-B60 Log
Node 3
Protect line
Working Path
for the working
Figure 4-1 on page
4-11),
4-11
Advertisement
Table of Contents
