Dlp-B242 Create A Blsr On A Single Node; Dlp-B303 Initiate A Blsr Force Ring Switch - Cisco ONS 15327 Procedure Manual

NTP-B12 Add a BLSR Node

DLP-B242 Create a BLSR on a Single Node

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, lick the Maintenance > BLSR tabs.
Step 1
In the Suggestion dialog box, click OK.
Step 2
Step 3 In the Create BLSR dialog box, enter the BLSR information:
•
•
•
•
•
•
Click OK.
Step 4
Note
Return to your originating procedure (NTP).
Step 5

DLP-B303 Initiate a BLSR Force Ring Switch

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15327 Procedure Guide, R4.0
13-6
Use this task to create a BLSR on a single node. The task is used when you
add a node to an existing BLSR or when you delete and then recreate a
BLSR temporarily on one node.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite
Provisioning or higher
Ring Type—Enter 2 Fiber. You cannot provision 4-Fiber BLSRs on ONS 15327s.
Ring ID—Enter the BLSR ring ID. If the node is being added to a BLSR, use the BLSR ring ID.
Node ID—Enter the node ID. If the node is being added to a BLSR, use an ID that is not used by
other BLSR nodes.
Ring Reversion—Enter the ring reversion time of the existing BLSR.
West Line—Enter the slot on the node that will connect to the existing BLSR via the node's west
line.
East Line—Enter the slot on the node that will connect to the existing BLSR via the node's east line.
Alarms are displayed and the BLSR is displayed as Incomplete until the node is connected to
other BLSR nodes.
Use this task to perform a BLSR Force protection operation on a BLSR
port.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite
Provisioning or higher
Chapter 13 Add and Remove Nodes
March 2003