Cisco ONS 15327 Procedure Manual page 227
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 5
Create Circuits and VT Tunnels
Protected Drops—Leave the default unchanged (unchecked).
•
If the circuit will be routed on a path protection, complete the
Step 9
Selectors During Circuit Creation" task on page
Click Next.
Step 10
Provision the circuit source:
Step 11
From the Node drop-down menu choose the hub node.
a.
From the Slot drop-down menu choose the Ethernet card where you enabled the single-card
b.
EtherSwitch.
Click Next.
Step 12
Provision the circuit destination:
Step 13
a.
From the Node drop-down menu choose an EtherSwitch circuit endpoint node.
From the Slot drop-down menu choose the Ethernet card where you enabled the single-card
b.
EtherSwitch.
Step 14
Click Next.
Review the VLANs listed in the Available VLANs area. If the VLAN you want to use appears, continue
Step 15
with
Step
Click the New VLAN button.
a.
On the New VLAN dialog box, complete the following:
b.
–
–
Click OK.
c.
In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
Step 16
move the VLAN to the Circuit VLANs column.
Note
Click Next.
Step 17
Confirm that the following information about the hub and spoke circuit is correct:
Step 18
Circuit name
•
•
Circuit type
•
Circuit size
•
VLAN names
ONS 15327 circuit nodes
•
If the circuit information is not correct, click the Back button and repeat the procedure with the correct
information.
Note
March 2003
17. If you need to create a new VLAN, complete the following steps:
VLAN Name—Assign an easily-identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15327 network supports
a maximum of 509 user-provisionable VLANs.
Moving the VLAN from Available VLANs to Circuit VLANs forces all the VLAN traffic to use
the shared packet ring you are creating.
You can also click Finish, delete the completed circuit, and start the procedure from the
beginning.
NTP-B143 Create an E-Series Hub and Spoke Ethernet Configuration
"DLP-B218 Provision Path Protection
5-27.
Cisco ONS 15327 Procedure Guide, R4.0
5-61
Advertisement
Table of Contents
