Ntp-B152 Delete Circuits - Cisco ONS 15327 Procedure Manual

Chapter 8 Manage Circuits
On the Circuit Upgrade Results dialog box, click OK.
Step 6
Stop. You have completed this procedure.

NTP-B152 Delete Circuits

Purpose
Tools/Equipment
Prerequisite Procedures Circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
Log into an ONS 15327 node on the network where you want to delete the circuit. See the
Step 1
Log into CTC" task on page 2-23
Complete the
Step 2
Investigate all network alarms and resolve any problems that may be affected by the circuit deletion.
Step 3
Refer to the Alarm Troubleshooting chapter in the Cisco ONS 15327 Troubleshooting Guide.
Verify that traffic is no longer carried on the circuit, using local site practices, and that the circuit can be
Step 4
safely deleted.
Click the Circuits tab.
Step 5
Choose the circuit(s) you want to delete, then click Delete.
Step 6
Step 7 On the Delete Circuits confirmation dialog box, check Set drop ports to OOS if you want to put the
circuit source and destination ports out of service. (CTC will place the ports out of service only if the
circuit is the same size as the port or is the only circuit using the port.) Click Yes to confirm the deletion.
Complete the
Step 8
Stop. You have completed this procedure.
March 2003
Use this procedure to delete circuits.
None
Tunnels" for circuit creation procedures.
As needed
Onsite or remote
Provisioning or higher
for instructions. If you are already logged in, continue with Step 2.
"NTP-B108 Back Up the Database" procedure on page
"NTP-B108 Back Up the Database" procedure on page
NTP-B152 Delete Circuits
Chapter 5, "Create Circuits and VT
14-6.
14-6.
Cisco ONS 15327 Procedure Guide, R4.0
"DLP-B60
8-15