Dlp-B245 Use The Reinitialization Tool To Clear The Database And Upload Software (Unix); Figure 14-11 Confirm Ne Restoration - Cisco ONS 15327 Procedure Manual

Chapter 14 Maintain the Node

Figure 14-11 Confirm NE Restoration

Return to your originating procedure (NTP).
Step 14
DLP-B245 Use the Reinitialization Tool to Clear the Database and Upload
Software (UNIX)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The XTC cards will reboot several times during this procedure. Wait until they are completely rebooted
Note
before continuing.
Insert the system software CD containing the reinitialization tool, the software, and the defaults database
Step 1
into the local craft interface PC drive. If the CTC Installation Wizard opens, click Cancel.
To find the recovery tool file, go to the CISCO15327 directory on the CD (usually
Step 2
/cdrom/cdrom0/CISCO15327).
If you are using a file explorer, double click the RE-INIT.jar file to open the reinitialization tool
Step 3
(Figure 14-12 on page
RE-INIT.jar.
March 2003
This task describes how to use the reinitialization tool in a UNIX
environment. Use this tool to clear the database on the XTC and restore
factory or customer defaults.
Software CD containing Release 4.0 software, the node's NE defaults,
and the reinitialization tool.
JRE 1.03_02 must also be installed on the computer you will use to
perform this procedure.
NTP-B108 Back Up the Database, page 14-6
As needed to clear the existing database from an XTC and restore the
node's default settings.
Onsite or remote
Superuser
14-14). If you are working with a command line interface, run
NTP-B163 Restore the Node to Factory Configuration
Cisco ONS 15327 Procedure Guide, R4.0
java -jar
14-13