Dlp-B154 Modify A 1+1 Protection Group - Cisco ONS 15327 Procedure Manual

Chapter 9 Change Node Settings

DLP-B154 Modify a 1+1 Protection Group

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Protection tabs.
Step 1
Step 2 Under Protection Groups, click the 1+1 protection group you want to modify.
Under Selected Group, you can modify the following:
Step 3
•
•
•
•
See the
Step 4 Click Apply. Confirm that the changes appear.
Note
Step 5 Return to your originating procedure (NTP).
March 2003
Use this task to modify a 1+1 protection group for any optical port (OC-3,
OC-12, or OC-48).
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Name—As needed, type the changes to the protection group name. The name can have up to 32
alphanumeric characters.
Bidirectional switching—As needed, check or uncheck
Revertive—Check this check box if you want traffic to revert to the working card after failure
conditions stay corrected for the amount of time chosen from the Reversion time menu. Uncheck if
you do not want traffic to revert.
Reversion time—If the Revertive check box is selected, choose the reversion time from the
Reversion time pull-down menu. The range is 0.5 to 12.0 minutes. The default is 5.0 minutes. This
is the amount of time that will elapse before the traffic reverts to the working card. Traffic can revert
when conditions causing the switch are cleared.
"NTP-B170 Create Optical Protection Groups" procedure on page 3-20
If the changes do not appear, repeat the task. Refer to the Cisco ONS 15327 Troubleshooting
Guide, as needed.
NTP-B203 Modify or Delete 1+1 Card Protection Settings
for field descriptions.
Cisco ONS 15327 Procedure Guide, R4.0
9-13