Dlp-B171 Change Sonet Thresholds Settings For Oc-N Cards - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 10
Change Port Settings
Table 10-8 OC-N Card Line Settings (continued)
Parameter
State
AINS Soak
Type
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-B171 Change SONET Thresholds Settings for OC-N Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
In node view, double-click the OC-N card where you want to change the SONET thresholds settings
(Figure
Step 2
Click the Provisioning > SONET Thresholds tabs
March 2003
Description
Places port in service,
out of service,
out of service-maintenance, or out of
service-auto in service.
Automatic in-service soak
Defines the port as SONET or SDH. The
Enable Sync Msg field and the Send Do
Not Use field must be disabled before the
port can be set to SDH.
This task changes SONET thresholds settings for OC-N cards.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
10-2).
NTP-B89 Modify Line Settings and PM Parameter Thresholds for Optical Ports
Options
•
•
•
•
•
•
•
•
(Figure
10-2).
Cisco ONS 15327 Procedure Guide, R4.0
IS
OOS
OOS_MT
OOS_AINS
Duration of valid input signal in
hh.mm after which the card is set in
service by the software.
0 to 48 hours, 15 minutes increments.
Sonet
SDH
10-11
Advertisement
Table of Contents
