Ntp-B 181 Create An Automatically Routed Ds-1 Circuit - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
h.
i.
j.
k.
Step 7 Repeat Step 6 for each node in the network.
As appropriate, complete the circuit creation procedure listed on page 5-1.
Step 8
Stop. You have completed this procedure.
NTP-B181 Create an Automatically Routed DS-1 Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
From the View menu choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box
Step 5
•
•
•
•
•
March 2003
Click the SONET DCC tab. Verify that SDCC(s) were created to the applicable OC-N slots and
ports. If DCCs were not created for the appropriate OC-N slots and ports, see
Network" and complete the turn-up procedure appropriate for your network topology.
Click the Timing tab. Verify that timing is provisioned as specified. If not, use the
Change Node Timing" procedure on page 9-15
Click the Alarm Behavior tab. If you provisioned optional alarm profiles, verify that the alarms are
provisioned as specified. If not, see the
Profiles" procedure on page 6-16
Verify that the network element defaults listed in the status area of the node view window is correct.
This procedure creates an automatically routed DS-1 circuit, meaning CTC
chooses the circuit route based on the parameters you specify and on the
software version.
None
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B314 Assign a Name to a Port" task on page
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters,
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Type—Choose VT. VT cross-connects will carry the DS-1 circuit across the ONS 15327 network.
Size—VT1.5 is the default. You cannot change it.
Bidirectional—Leave checked for this circuit.
Number of circuits—Type the number of DS-1 circuits you want to create. The default is 1. If you
are creating multiple circuits with the same slot and sequential port numbers, you can use
Auto-ranged to create the circuits automatically.
NTP-B181 Create an Automatically Routed DS-1 Circuit
to make the changes.
"NTP-B70 Create, Download, and Assign Alarm Severity
to change the information.
at a node on the network where you will
(Figure 5-1 on page 5-7), complete the following fields:
Cisco ONS 15327 Procedure Guide, R4.0
Chapter 4, "Turn Up
Step 2.
5-16. If not, continue with
"NTP-B85
Step 3.
5-5