Ntp-B220 Install The Electrical Cables - Cisco ONS 15327 Procedure Manual

Chapter 1 Install Hardware

NTP-B220 Install the Electrical Cables

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Always use the supplied ESD wristband when working with a powered ONS 15327. Plug the wristband
cable into the ESD jack located between the top traffic and XTC slots.
Step 1 Complete the
Step 2 Complete the
Complete the
Step 3
Continue with the
Step 4
Stop. You have completed this procedure.
March 2003
This procedure describes how to install the electrical DS-1 (AMP Champ)
and DS-3 (coaxial) cables. To carry electrical traffic on the ONS 15327,
you must install electrical cable.
Shielded coaxial cable terminated with BNC connectors for DS-3 ports
Shielded ABAM cable terminated with Champ connectors for DS-1 ports
with #22 or #24 AWG ground wire (typically about two feet in length)
NTP-B8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections,
page 1-28
As needed
Onsite
None
"DLP-B324 Install DS-1 Champ Cables on a MIC" task on page 1-34
"DLP-B325 Install Coaxial Cable With BNC Connectors" task on page 1-38
"DLP-B326 Route Electrical Cables" task on page 1-39
"NTP-B221 Install Optical Cables" procedure on page
NTP-B220 Install the Electrical Cables
as needed.
as needed.
1-40.
Cisco ONS 15327 Procedure Guide, R4.0
as needed.
1-33