Table 10-5 Line Options For Ds-3 Ports - Cisco ONS 15327 Procedure Manual

Chapter 10 Change Port Settings
In the node view, double-click the XTC-28-3 card where you want to change the DS-3 line or threshold
Step 1
settings.
Click the Provisioning tab.
Step 2
Click the DS-3 tab.
Step 3
Depending on the setting you need to modify, click the Line, Line Thresholds, STS-1 Path Threshold,
Step 4
or Alarm Behavior subtab.
Note
Step 5 Modify any of the settings found under these subtabs. For definitions of the Line settings, see
on page
of the SONET Threshold settings, see
For the factory default settings for the DS-3 ports, see
Step 6 Click Apply.
Step 7 Repeat Steps
Table 10-5

Table 10-5 Line Options for DS-3 Ports

Parameter
Port #
Port
Line Length Defines the distance (in feet) from
State
AINS Soak
Table 10-6
March 2003
See Chapter 6, "Manage Alarms"
10-7. For definitions of the Line Threshold settings, see
5 and 6 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line subtab for the DS-3 ports.
Description
Port number
Port name
backplane connection to the next
termination point
Places port in service,
out of service,
out of service-maintenance, or out of
service-auto in service.
Automatic in-service soak
describes the values on the Provisioning > Line Thresholds subtab for the DS-3 ports.
NTP-B88 Modify Line Settings and PM Parameter Thresholds for Electrical Ports
for information about the Alarm Behavior subtab.
Table 10-7 on page 10-8.
Table C-2 on page
Options
1 to 3
User-defined, up to 32 alphanumeric/
special characters. Blank by default.
See DLP-B314 Assign a Name to a Port,
page
0 - 225 (default)
•
226 - 450
•
IS
•
OOS
•
OOS_MT
•
OOS_AINS
•
Time of presence of valid input signal in
hh.mm after which the port is set in
service by the software. 0 to 48 hours, 15
minutes increments.
Cisco ONS 15327 Procedure Guide, R4.0
Table 10-6 on page 10-8. For definitions
C-7.
5-16.
Table 10-5
10-7