Ntp-B144 Create An E-Series Single-Card Etherswitch Manual Cross-Connect - Cisco ONS 15327 Procedure Manual

NTP-B144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect

Click Finish.
Step 19
Complete the
Step 20
Complete the
Step 21
Complete the
Step 22
To create additional circuits ("spokes"):
Step 23
a.
b.
Stop. You have completed this procedure.
NTP-B144 Create an E-Series Single-Card EtherSwitch Manual
Cross-Connect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In this procedure, cross-connect refers to a circuit connection created within the same node between the
Note
Ethernet card and an OC-N card connected to third-party equipment. You create cross-connects at the
source and destination nodes so an Ethernet circuit can be routed from source to destination across
third-party equipment.
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
If a high number of VLANs is already used by the network, complete the
Step 3
Available VLANs" task on page 5-68
create a VLAN during each circuit creation task).
Step 4 Verify that the Ethernet card that will carry the circuit is provisioned for Singlecard EtherSwitch. See
the
Step 5 From the View menu choose Go to Network View.
Click the Circuits tab and click Create.
Step 6
Cisco ONS 15327 Procedure Guide, R4.0
5-62
"DLP-B220 Provision E-Series Ethernet Ports" task on page
"DLP-B221 Provision E-Series Ethernet Ports for VLAN Membership" task on page
"NTP-B146 Test E-Series Circuits" procedure on page
Complete the "DLP-B99 Determine Available VLANs" task on page 5-68
VLAN capacity is available for the circuit destination node.
Repeat Steps 3 through 22.
This procedure creates Single-Card EtherSwitch cross-connects between
E-Series Ethernet cards and OC-N cards connected to non-ONS
equipment.
E-Series Ethernet cards must be installed at the circuit source node.
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B314 Assign a Name to a Port" task on page
"DLP-B246 Provision E-Series Ethernet Card Mode" task on page
at a node on the network where you will
Step
to verify that sufficient VLAN capacity is available (you will
Chapter 5 Create Circuits and VT Tunnels
5-69.
5-72.
to verify that sufficient
2.
5-16. If not, continue with
"DLP-B99 Determine
5-69.
5-70.
Step 3.
March 2003