Dlp-B189 Verify That A 1+1 Working Slot Is Active - Cisco ONS 15327 Procedure Manual

Chapter 12 Convert Network Configurations
(Linear ADM only) Physically remove the protect fibers from all nodes in the linear ADM.
Step 10
Create the ring by connecting the protect fiber from one end node to the protect port on the other end
Step 11
node.
Note
From the network view, click the Circuits tabs and complete the
Step 12
page 6-3
Complete the
Step 13
provision the slot in each node that is not already in the SDCC Terminations list.
Deleting circuits is service affecting.
Caution
For circuits provisioned on an STS that is now part of the protection bandwidth (STSs 7 to 12 for an
Step 14
OC-12 BLSR, and STSs 25 to 48 for an OC-48 BLSR), delete and recreate each circuit:
a.
b.
c.
Complete the
Step 15
Stop. You have completed this procedure.

DLP-B189 Verify that a 1+1 Working Slot is Active

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node view, click the Maintenance > Protection tabs.
Step 1
Step 2 In the Selected Group pane, verify that the working slot/port is shown as Working/Active. If so, this task
is complete.
If the working slot says Working/Standby, manually switch traffic to the working slot:
Step 3
a.
b.
March 2003
If you need to physically remove any OC-N cards, do so now. See the
Replace a Card" procedure on page
to save the circuit data to a file on your hard drive.
"DLP-B253 Provision SONET DCC Terminations" task on page 4-5
Complete the "NTP-B152 Delete Circuits" procedure on page 8-15
Create the circuit on STSs 1 to 6 for an OC-12 BLSR, or on STSs 1 to 24 for an OC-48 BLSR on
the fiber that served as the protect fiber in the linear ADM. See the
Routed Optical Circuit" procedure on page 5-43
Repeat Steps a and b for each circuit residing on a BLSR protect STS.
"NTP-B126 Create a BLSR" procedure on page 4-15
This task verifies that a working slot in a 1+1 protection scheme is active
(and that the protect slot is in standby).
None
DLP-B60 Log into CTC, page 2-23
As needed
Both
Maintenance or higher
In the Selected Group pane, choose the Protect/Active slot.
In the Switch Commands field, choose Manual.
NTP-B155 Convert a Point-to-Point or a Linear ADM to a Two-Fiber BLSR
1-25.
"DLP-B139 Export CTC Data" task on
for instructions.
to put the nodes into a BLSR.
Cisco ONS 15327 Procedure Guide, R4.0
"NTP-B219 Remove and
at the end nodes;
for one circuit.
"NTP-B189 Create a Manually
12-5