Cisco ONS 15327 Procedure Manual page 440

NTP-B114 Power Down the ONS 15327
Note
Continue with
If the node is not connected to a working network and the current configurations are no longer
b.
required, proceed to
Note
In node view, click the Circuits tab and verify that no circuits are displayed, then proceed to
Step 3
circuits are displayed, delete all the circuits that originate or terminate in the node, as follows:
Click the circuits that need to be deleted and click Delete.
a.
b. Click Yes.
Repeat until no circuits are displayed.
Complete the
Step 4
delete any optical protection group. You cannot delete the default electrical protection group,
XTCPROTGRP.
Repeat until all protection groups are deleted.
Step 5 Complete the
Repeat until no SDCC Terminations appear.
Step 6 Complete the
Out of Service (OOS).
Step 7 Remove all fiber connections to the cards.
Step 8 Complete the
XTC card.
Click Yes.
Step 9
After you have deleted the card, open the card ejectors and remove it from the node.
Step 10
Open the ejectors and remove the XTC card from the node. Repeat for the second XTC.
Step 11
Shut off the power from the power supply that feeds the node.
Step 12
Disconnect the node from its external fuse source.
Step 13
Store all the cards you removed and update inventory records according to local site practice.
Step 14
Stop. You have completed this procedure.
Cisco ONS 15327 Procedure Guide, R4.0
15-2
If the node is in a linear ADM configuration,
Step 3.
Step 3.
Current configurations will be saved if Steps
"NTP-B203 Modify or Delete 1+1 Card Protection Settings" procedure on page 9-12
"NTP-B204 Delete a SONET DCC Termination" procedure on page 9-14
"DLP-B230 Change a Circuit State" task on page 8-8
"DLP-B320 Delete a Card" task on page 1-26
Chapter 15
Step 4 will delete the topology.
3 through 12 are skipped.
to change all ports in each card to
for all traffic cards. You cannot delete an
Power Down the Node
Step 4. If
to
for all cards.
March 2003