Ntp-B25 Set Up Name, Date, Time, And Contact Information - Cisco ONS 15327 Procedure Manual

Chapter 3 Turn Up Node
•
Note
Step 5 Under "Select applicable nodes," deselect any nodes where you do not want to add the user (all network
nodes are selected by default).
Step 6 Click OK.
On the User Creation Results dialog box, click OK.
Step 7
Return to your originating procedure (NTP).
Step 8

NTP-B25 Set Up Name, Date, Time, and Contact Information

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with Step 2.
Click the Provisioning > General tabs.
Step 2
Enter the following information in the fields listed:
Step 3
•
•
•
•
You can also position nodes manually on the network view map. Press Ctrl while you drag and drop the
Tip
node icon to the desired location. To create a network map that is visible to all ONS 15327 users,
complete the
March 2003
Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the Cisco ONS 15327 Reference Manual for
information about the capabilities provided with each level.
The idle time is the length of time that CTC can remain idle before it locks up and the password
must be reentered. Each security level has a different idle time: Retrieve user = unlimited,
Maintenance user = 60 minutes, Provisioning user = 30 minutes, and Superuser = 15 minutes.
This procedure provisions identification information for the node,
including the node name, a contact name and phone number, the location
of the node, and the date, time, and time zone.
None
NTP-B24 Verify Card Installation, page 3-2
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
Node Name—Type a name for the node. For TL1 compliance, names must begin with an alpha
character and have no more than 20 alphanumeric characters.
Contact—Type the name of the node contact person and the contact phone number up to 255
characters (optional).
Latitude—Enter the node latitude: N (North) or S (South), degrees, and minutes (optional).
Longitude—Enter the node longitude: E (East) or W (West), degrees, and minutes (optional).
"NTP-B172 Create a Logical Network Map" procedure on page
NTP-B25 Set Up Name, Date, Time, and Contact Information
for the node you will turn up. If you are
4-3.
Cisco ONS 15327 Procedure Guide, R4.0
3-5