Ntp-B115 Preprovision A Slot; Ntp-B8 Install Wires To Alarm, Timing, Lan, And Craft Pin Connections - Cisco ONS 15327 Procedure Manual

NTP-B115 Preprovision a Slot

NTP-B115 Preprovision a Slot
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into the ONS 15454. See the
Step 1
(default) view displays. If you are already logged in, continue with
Right-click the empty slot where you will later install a card.
Step 2
From the Add Card popup menu, choose the card type that will be installed.
Step 3
Note
Continue with the
Step 4
Stop. You have completed this procedure.
NTP-B8 Install Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2 Complete the
necessary to provision external timing.
Step 3 Complete the
Craft wires are required to access TL1 using the craft interface.
Cisco ONS 15327 Procedure Guide, R4.0
1-28
This procedure describes how to preprovision a slot in the software before
physical card installation.
None
Chapter 2, "Connect the PC and Log into the GUI"
As needed
Onsite or Remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
When you preprovision a slot, the card appears purple in the CTC shelf display, rather than white
when a card is physically in the slot.
"NTP-B221 Install Optical Cables" procedure on page
This procedure describes how to install alarm, timing, LAN, and craft
wires.
Alarm cable, CAT-5 terminated with RJ-45 for all alarm connections
#22 or #24 shielded AWG wire
NTP-B2 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
"DLP-B321 Install External Alarm Cables" task on page 1-29
"DLP-B322 Install Timing Cables" task on page 1-30
"DLP-B323 Install the Serial Cable for TL1 Craft Interface" task on page 1-32
Chapter 1 Install Hardware
for instructions. The node
Step 2.
1-40.
as necessary.
as needed. Timing wires are
as needed.
March 2003