Cisco ONS 15327 Procedure Manual page 36

NTP-B2 Install the Shelf Assembly
DLP-B5 Mount the ONS 15327 in a Rack
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Mounting the ONS 15327 in a rack requires a minimum of 5.2 inches of vertical rack space (plus 1 inch
Note
for air flow). To ensure the mounting is secure, use two to four #12-24 mounting screws for each side of
the shelf assembly.
Verify that the proper fuse and alarm panel has been installed in the top mounting space. If a fuse and
Step 1
alarm panel has not been installed, you must install one according to manufacturer's instructions. A fuse
panel with two 10-amp fuses per shelf is required for Power A and B feeds.
Ensure that the shelf assembly is set for the desired rack size (either 19 or 23 inches).
Step 2
Lift the shelf assembly to the desired rack position and set it on the set screws.
Step 3
Align the screw holes on the mounting ears with the mounting holes in the rack.
Step 4
Using the Phillips screwdriver, install one mounting screw in each side of the assembly.
Step 5
When the shelf assembly is secured to the rack, install the remaining mounting screws.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-B7 Mount Multiple Shelf Assemblies in a Rack
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15327 Procedure Guide, R4.0
1-8
This task allows one person to mount the shelf assembly in a rack.
Two sets of #12-24 mounting screws
# 2 Phillips screwdriver
Fuse and alarm panel, if not installed
DLP-B3 Reverse the Mounting Bracket to Fit a 19-inch Rack, page
applicable
As needed
Onsite
None
This task installs multiple shelf assemblies in a rack.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
DLP-B3 Reverse the Mounting Bracket to Fit a 19-inch Rack, page
applicable
As needed
Onsite
None
Chapter 1 Install Hardware
1-6, if
1-6, if
March 2003