Figure 7-1 Line Tab For Enabling Pointer Justification Count Parameters - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 7
Monitor Performance
Click the Provisioning > Line tabs.
Step 2
Click the PJStsMon# menu and make a selection based on the following rules.
Step 3
The default value Off means pointer justification monitoring is disabled.
•
The values 1 to N are the number of STSs on the port. One STS per port can be enabled from the
•
PJStsMon# card menu.
Figure 7-1
Figure 7-1
Line tab
In the State field, confirm that the port is in service (IS).
Step 4
If the port is IS, click Apply and go to
Step 5
If the port is out of service (OOS, OOS_MT, OOS_AINS), select IS in the State field and click Apply.
Step 6
Click the Performance tab to view PM parameters.
Step 7
to the Cisco ONS 15327 Reference Manual for more PM information, details, and definitions.
Note
March 2003
shows the PJStsMon# menu on the Provisioning window.
Line Tab for Enabling Pointer Justification Count Parameters
Provisioning tab
On CTC, the count fields for PPJC and NPJC PM parameters appear white and blank unless they
are enabled on the Provisioning > Line tabs.
Card view
PJStsMon#
Step
7.
Figure 7-2
shows pointer justification counts. Refer
Cisco ONS 15327 Procedure Guide, R4.0
NTP-B73 Enable Performance Monitoring
7-3
Advertisement
Table of Contents
