Dlp-B75 Create A New User - Multiple Nodes - Cisco ONS 15327 Procedure Manual

NTP-B30 Create Users and Assign Security
•
•
•
Note
Click OK.
Step 4
Return to your originating procedure (NTP).
Step 5

DLP-B75 Create a New User - Multiple Nodes

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
All nodes where you want to add users must be accessible in network view.
Note
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Security > Users tabs.
Step 2
In the Security window, click Create.
Step 3
In the Create User dialog box, enter the following:
Step 4
•
•
•
Cisco ONS 15327 Procedure Guide, R4.0
3-4
Password—Type the user password. The password must be a minimum of six and a maximum of 20
alphanumeric (a-z, A-Z, 0-9) and special characters (+, #,%), where at least two characters are
non-alphabetic and at least one character is a special character. For TL1 compatibility, the password
must have 6 to 10 characters, and the first character must be an alpha character. The password cannot
contain the user name.
Confirm Password—Type the password again to confirm it.
Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the Cisco ONS 15327 Reference Manual for
information about the capabilities provided with each level.
The idle time is the length of time that CTC can remain idle before it locks up and the password
must be reentered. Each security level has a different idle time: Retrieve user = unlimited,
Maintenance user = 60 minutes, Provisioning user = 30 minutes, and Superuser = 15 minutes.
This task adds a new user to multiple ONS 15327s.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Name—Type the user name. The name must have a minimum of six and a maximum of 20
alphanumeric characters (a-z, A-Z, 0-9). For TL1 compatibility, the user name must have no more
than 10 characters, and the first character must be an alpha character.
Password—Type the user password. The password must have a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special characters (+, #,%), where at least two characters are
non-alphabetic and at least one character is a special character. For TL1 compatibility, the password
must be 6 to 10 characters, and the first character must be an alpha character. The password cannot
contain the user name.
Confirm Password—Type the password again to confirm it.
Chapter 3 Turn Up Node
March 2003