Dlp-B116 Apply Alarm Profiles To Ports - Cisco ONS 15327 Procedure Manual

Chapter 6 Manage Alarms
b.
Return to your originating procedure (NTP).
Step 10

DLP-B116 Apply Alarm Profiles to Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To change alarm profiles for optical cards, proceed to
Step 1
ports, proceed to
To change alarm profiles for optical cards, double-click an optical card in node view to display the card
Step 2
view.
Note
Note
Click the Provisioning > Alarm Behavior tabs.
Step 3
Figure 6-10
November 2004
Click OK.
Use this task to apply a custom or default alarm severity profile to a port
or ports.
None
DLP-B115 Create Alarm Severity Profiles, page 6-17
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Step 4. To apply alarm profiles to electrical card ports, proceed to
You can also apply alarm profiles to cards using the
and Nodes" task on page
The card view is not available for the MIC-A or MIC-B cards.
shows an alarm profile for OC-3 card ports. CTC shows Parent Card Profile: Inherited.
NTP-B70 Create, Download, and Assign Alarm Severity Profiles
Step 2. To apply alarm profiles to optical card
6-24.
Cisco ONS 15327 Procedure Guide, R4.0
Step
"DLP-B117 Apply Alarm Profiles to Cards
8.
6-21