Ntp-B85 Change Node Timing; Dlp-B157 Change The Node Timing Source - Cisco ONS 15327 Procedure Manual

Chapter 9 Change Node Settings

NTP-B85 Change Node Timing

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the
Step 2
As needed, complete the
Step 3
If you need to change any internal timing settings, follow the
Step 4
on page 3-19
Internal timing is Stratum 3 and not intended for permanent use. All ONS 15327s should be timed to a
Caution
Stratum 2 or better primary reference source.
If you need to verify timing after removing a node from a BLSR or a path protection, see the
Step 5
Verify BLSR Pass-Through Circuits" task on page
Step 6 Complete the
Stop. You have completed this procedure.

DLP-B157 Change the Node Timing Source

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The following procedure may be service affecting and should be performed during a scheduled
Caution
maintenance window.
In node view, click the Provisioning > Timing tabs.
Step 1
In the General Timing section, change any of the following information:
Step 2
•
March 2003
This procedure changes the SONET timing settings for the ONS 15327.
None
NTP-B28 Set Up Timing, page 3-16
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page
"NTP-B108 Back Up the Database" procedure on page
"DLP-B157 Change the Node Timing Source" task on page
for the settings you need to modify.
"NTP-B108 Back Up the Database" procedure on page
This task changes the SONET timing source for the ONS 15327
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Timing Mode
NTP-B85 Change Node Timing
2-23. If you are already logged in, continue with
14-6.
"DLP-B70 Set Up Internal Timing" task
13-11.
14-6.
Cisco ONS 15327 Procedure Guide, R4.0
9-15.
"DLP-B304
9-15